How To Avoid Overheating Of Busbar Processing Machine

During the continuous use of the busbar processing machine, it is easy to cause overheating, which accelerates the damage speed of the busbar processing machine. How to avoid overheating and improve the service life of the busbar processing machine has become our research topic, and the following points should be paid attention to:

1. Make the motor of the busbar processing machine clean. If dust, water stains, and other debris enter the interior of the motor during operation, it will form a short-circuit medium, which can damage the insulation layer of the wire, cause inter turn short circuit, increase current, and temperature, and burn the motor. Therefore, it is necessary to prevent dust, water stains, and other debris from entering the interior of the motor. At the same time, it is necessary to regularly clean the exterior of the motor and avoid dust and other debris in the heat dissipation ribs of the motor to ensure good heat dissipation.

2. Observe and listen carefully, and stop the machine immediately when you smell a strange smell. Observe the motor for vibration, noise, and abnormal odor. During the operation of the busbar processing machine motor, especially for high-power motors, it is necessary to frequently check whether the anchor bolts, motor end covers, bearing glands, etc. are loose, and whether the grounding device is reliable. If it is found that the motor vibration intensifies, the noise increases, and there is an odor, it must be stopped as soon as possible to identify the cause and eliminate the fault.

3. To ensure that the working current of the busbar processing machine motor is not too high. Motor overload operation can occur due to excessive load, low voltage, or mechanical jamming caused by being driven. Therefore, during the operation of the electric motor, it is necessary to regularly check whether the transmission device operates flexibly and reliably; Is the concentricity of the coupling standard; Flexibility of gear transmission, etc. If any jamming is found, the machine should be immediately shut down to troubleshoot before running.

4. Regularly inspect and repair the control equipment of the busbar processing machine motor to ensure its normal operation. The technical condition of the motor control equipment plays a decisive role in the normal start-up of the motor. Therefore, the control equipment of the electric motor should be located in a dry, ventilated, and easy to operate position, and regularly remove dust. Regularly check the reliability of contactor contacts, coil cores, and various wiring screws, as well as the flexibility of mechanical parts to maintain good technical condition, in order to ensure the smooth operation of the motor without being burned.