Common Issues in Busbar Machine Selection And Process Technology

The three pump and three station busbar machine is equipped with three independent hydraulic systems. The three stations can operate synchronously without competing for pressure, supporting multi person operation and higher efficiency than single pump and dual pump models. The equipment can complete copper bar cutting, punching, and bending in one stop, with good rigidity and stable processing accuracy, suitable for mass production. Bending molds can be selected as standard molds or customized according to needs; The processing range of punching molds is from 4.3mm to 30mm, which can be used for circular holes, square holes, elliptical holes, corner cutting, etc. The hole surface is smooth and free of burrs, and supports customized non-standard shaped molds

When selecting busbar machines in the workshop, it is recommended to use the largest copper aluminum busbar specification on site as the benchmark, reserve 20% -30% processing allowance, and make a comprehensive judgment based on their own punching and bending process requirements. Customers can send busbar samples to the factory for free trial runs to verify the actual processing effect. Our factory has a complete range of busbar machine models and various processing molds, catering to both domestic workshop production and overseas foreign trade orders, meeting the processing needs of busbars in the fields of high and low voltage distribution and new energy.