Ways To Keep Busbar Processing Machines in Good Working Order

We all know that after a period of time any machine will feel slow, not so delicate operation, the disposal of the product is not so lubricated. Busbar processing machine is also the same, the initial buy when you feel good to use, the more you use the more you feel that the machine does not feel so right, but this is not the machine's own problems, how to make busbar processing machine has always had a good operating situation?
1, in the use of the time to have the basic maintenance, can not be allowed to develop, so we should focus on the bus bar processing machine for punctual protection and maintenance. Often adhere to do a little, than found to send to repair, more time-saving. Busbar processing machine moving parts to keep clean, several times a day to give oil to ensure that the normal work of the units, daily before starting the machine to check the oil level of each pipeline, electrical whether there are abnormalities, such as abnormalities please promptly remove after work. Regularly check (every working day) the level meter in the oil tank, please replenish in time when the oil is insufficient, the hydraulic oil must use the specified type of anti-wear hydraulic oil.
2, on the other hand, busbar processing machine is often in the process of overload operation, busbar processing machine for a long time after use, must let it take a break, we then check to check the wear and tear of the components and so on, a brief adjustment and then let it step into the workplace, continue the high pressure work. The machine has not been used for a long time (more than two weeks), when starting again, to clean and organize the moving parts, and lubrication, the machine needs to be airborne for 5-10 minutes after the start, run several times without abnormalities and then work. Busbar processing machine in the long-term use, can not reach the use of pressure, please adjust the relief valve, adjustment, loosen the lock nut, clockwise rotation of the bolt for increased pressure, and vice versa for lower pressure. Press the back button to the upper stop position, continuous pressure, see the pressure gauge pointer at about 25 MPa (punching, shear pressure of 28 MPa, bending pressure according to the row after the adjustment to 16-20 MPa), test whether the work can reach the normal work, screw the lock nut.
3, there is another point is to prohibit workers do not read the application instructions on the initial random operation. Wrong operation method whether the bus bar processing machine or the operator are caused by the hidden danger. The purchaser must deepen counseling on the situation, do a good job on every detail, so that the busbar processing machine use a little longer life, use a little better.