Steps To Replace The Punching Die Of The CNC Busbar Processing Machine

The CNC busbar processing machine mainly processes various specifications of copper and aluminum bus bars. The three stations can operate at the same time without affecting each other, and the production efficiency is high. The turret type bus processing machine is an indispensable ideal equipment in the electrical industry. The punching unit adopts a turret mold library, which can hold up to eight sets of molds. How should the punching mold be replaced?

Replacement method:

1. Raise the punching unit of the CNC busbar processing machine to the highest point and remove the positioning pointer.

2. Upper mold replacement: First, turn the turntable to turn the mold that needs to be replaced out of the working position. At this time, you can directly take out the top mother, the pressing block, the pressing block pad and the upper mold connecting rod, and then the upper mold can be removed. Replace the required upper die (upper die and upper die connecting rod must be tight).

3. Lower mold replacement: loosen the top wire that fastens the lower mold and the lower mold pad to install or replace the lower mold.

4. For non-round holes (long round holes, square holes, etc.), be careful not to install them in the wrong direction. Remember to tighten the fastening screws of the lower mold, otherwise the mold will be damaged.

5. Replacing the embossing mold: As long as the upper and lower templates are drawn out and the embossing mold is replaced, no other adjustments are required.

Special attention: The power supply of the equipment must be turned off when replacing the mold to avoid personal injury caused by misoperation; the mold must be kept clean; during the punching operation, frequent inspections are required, and the handwheel must be tightened to prevent loosening causing offset and damaging the mold.

After the punching die of the CNC bus processing machine is replaced, the punching operation can be carried out. Place the material on the worktable, insert the positioning pointer, and move the material to punch the good sample. For punching operations, the same batch of materials can be matched with a ruler slider and a ruler, without proofing and punching, and the punching work can be completed efficiently.

Turn on the power switch of the turret-type bus processing machine equipment, step on the foot switch, the unit oil pump starts, and then step on the punching unit foot switch, the punch will move forward, release the foot switch during the forwarding process, the punch will stop Run, step on the foot switch again, the punch will continue to move forward, when approaching the limit switch, the punch will automatically return to the top dead center. When the punch needs to return during this process, press the corresponding manual back button, the punch will go back, release the back button, the punch will stop backing.